The method of saving EDM brass wires in the processing of WEDM

EDM brass wires has good mechanical properties, thermoplasticity, cold plasticity, cutting property, and has the characteristics of easy brazing, corrosion resistance, corrosion cracking and so on. Nowadays, EDM brass wires is widely used in WEDM processing of various brands.Most of the time, if the processing method is not correct, a lot of EDM brass wires will be wasted.Today, we take Sodick as an example to talk about saving EDM brass wires.genos1818

1.Take Sodick machine cutting T=50MM, three knives as an example, first add three knife work condition line speed 130 to 50, 60, 70. Then add in front of the program:
         TP0
         TN50
         BSAH000 H000=0.005
This is equivalent to adding the taper of 0.005MM to the program, thus avoiding the problem of too low line speed and large upper and lower workpiece.

2.When machining workpiece, it can reduce the servo speed and speed up the processing speed to save EDM brass wires. Taking T=50MM 0.25 copper wire cutting hole as an example, the two or three knife servo speed 60307050 is changed to 61007100. three knife compensation.

         H001=0.180  
         H002=0.140

         H003=0.130

The above two methods are the experience of our KENOS employees. We hope these can help you. At the same time, KENOS also provides Zinc coated EDM wire and EDM brass wire for various brands of WEDM processing with a variety of models, you can feel free to buy.

genos1818

Above article from KENOS official website (http://www.edm-accessories.com/)
The original addres:（http://www.edm-accessories.com/EDM_brass_wires.html）